Ground
Drill - 9
MEASUREMENT FOUNDATION
Ground
Drill - 9
Ground
Drill - 9
9
If engine power drops, there are difficulties to start it or it
runs bad at no load - first check the spark plug. Clean the
spark plug if it´s dirty. Check electrode gap. If necessary,
make readjustment. Electrode gap should be 0.6mm.
Gear (pic. 11)
Every 50 h of operation check lubricant level in the gear
or gear system by way of disposal of priming plug for
lubricant on the side of gear. If you don´t see lubricant on
the gear wheels, fill the gear 3/4 with universal lithium
grease. Don´t fill the gear fully.
Fuel filter (pic.12)
Remove fuel from the fuel tank into an approved fuel con
-
tainer and take out a lign of fuel filter from the fuel
tank. Take out filter element and wash it with warm warter
with detergent. Dry the element on the air.
Replace the fuel filter If it´s hard and very dirty.
Muffler cleaning (pic.13)
Demount muffler and spark gap switch (if you have it)
and remove exhaust carbon from exhaust port or entrance
of the muffler every 100h of operation.
Pic. 8
Pic. 9
Pic. 10
Pic. 11
Summary of Contents for GroundDrill-9
