7
English
TO CHECK THE ACCURACY OF LINE LASER (SLOPE OF PLANE)
Place line laser on the tripod 5m away from the wall so the horizontal laser
line will be directed to the wall. Switch on the power. The line laser starts
to self-level. Mark point A on the wall to show the contact of laser beam
with the wall. Turn the line laser by 90° and mark points В, С, D on the wall.
Measure distance “h” between the highest and lowest points (these are A
and D points in the picture).If “h”is ≤ 6 mm, the measurement accuracy is
good. If “h” exceeds 6 mm, apply service center.
TO CHECK PLUMB
Choose a wall and set laser 5 m away from the wall. Hang a plumb with the
length 2.5 m on the wall. Turn on the laser and make the vertical laser line
meet the point of the plumb. The accuracy of the line is in the range if the
vertical line doesn’t exceed (up or down) the accuracy that is shown in the
specifications (e.g. ±3 mm/10 m). If the accuracy isn’t corresponding with
claimed accuracy, contact the authorized service center.
PRODUCT LIFE
Product life of the tool is 7 years. The battery and the tool should never
be placed in municipal waste. Date of production, manufacturer’s contact
information, country of origin are indicated on the product sticker.
CARE AND CLEANING
Please handle line laser with care. Clean with soft cloth only after any use.
If necessary damp cloth with some water. If instrument is wet clean and
dry it carefully. Pack it up only if it is perfectly dry. Transport in original
container/case only.
8
