Ada ULTRALINER 360 2V, Operating Manual

6

English

3. Bubble level
4. Sensitive element
5. Sound Off button
6. Clamp on the staff
7. Dynamic loudspeaker

APPLICATION OF THE DETECTOR 

Application of the detector is a decisive advantage when working outside 
in sunny weather. Press button (3) to switch on the detector mode. Open 

the battery cover and insert the battery into the detector. Press On/Off 

button to switch on the detector. Bring the receiver to the place of beam 
location. When laser beam will be on the sensitive element, there will be 

sound alarm and one of the LEDs will flash. LED will show the direction 

for the receiver for beam detection. Move the receiver until you will hear 

continious sound alarm and middle signal LED will flash. With the help of 

bubble level check the leveling of the receiver housing. Mark the surface. 

Place the detector on the staff with the help of clamp. 

         TO CHECK THE ACCURACY OF LINE LASER (SLOPE OF PLANE)

Place line laser on the tripod 5m away from the wall so the horizontal laser 
line  will be directed to the wall.  Switch on the power.  The instrument 
starts to self-level. Mark point A on the wall to show the contact of laser 

beam with the wall. Turn the instrument by 90° and mark points В, С, D 

on the wall. Measure distance “h” between the highest and lowest points 

(these are A and D points in the picture). If  “h”is  ≤ 6 mm, the measurement 

accuracy is good. If “h” exceeds 6 mm, apply service center.

TO CHECK PLUMB

Choose a wall and set laser 5 m away from the wall. Hang a plumb with 
the length 2.5 m on the wall. Turn on the laser and make the vertical laser 

5