© Adam Equipment Company 2006
3
4.0 SETTING UP THE SCALE
•
Take the Physician scale out of the box.
•
Remove the three screws from the bottom of the pillar.
•
Place and rotate the pillar and secure it to an upright position
using the three screws and connect the cable by fixing the
connector.
•
Slide the pole cover to the bottom.
•
Remove the screw at the top of the pillar and turn the
indicator panel to 180 degree. Tighten the screw until the
indicator panel is secured.
•
Position the height measuring rod and secure it by fixing its
threaded end.
•
Connect the adapter power supply to the main power supply
and put the switch at the rear of the scale to ON.
5.0 WEIGHING
•
Place the Physician Scale on an even floor and press the
[On/Off]
key.
•
The instrument performs a self-test after which it is ready for
operation. The display will show “
0.0
” with an arrow symbol,
above
kg
or
lb
, indicating the last chosen unit.
•
The arrow above
Stab
will be on when the reading is stable.
•
Press the
[On/Off]
key to switch off the scale. If the scale is
not to be used for a long time, the main power switch should
be turned off to save the battery life.
•
To start weighing, press
[On/Off]
, the scale will show “
0.0
”.
