EN
© Adam Equipment Company 2014
1 5
(P.N. 3136611622
- Revision D, Apr 2014)
12.0
SERVICE
PARAMETERS
The scales will allow entry to the parameters if the [Tare] key is pressed
during the power on cycle. The passcodes work as explained earlier.
In this case the display will show the passcode request screen, “
P - - - -
“ . To
continue enter a passcode as described below.
Entering passcode 0000 will allow calibration as shown in section 11.
Entering 1000 will allow access to a limited set of parameters described in
section 12.1.
12.1
USING
THE
SERVICE
PARAMETERS
Press the [0/T] key during the display countdown when turning on,
When “
Pn
“ is displayed, enter the number 1000 using the [Unit/
] and
[PCS/ ] keys and then press [0/T].
The display will show the first parameter called “
F4 Int
”.
To select another parameter press the [PCS/ ] key which will advance
through the parameters available. Full details are in the full version of the
user manual.
