Chapter 4 Deployment of the CPU 821xNET
CPU ADAM 821x
4-40
ADAM 8000 Manual CPU 821x – Rev 1.1
1
4
3
7
2
5
6
This dialog window gives you information about your specified Host-CP.
Input fields
Remote Host
IP address of the station where the data will be saved.
Remote Port
Port address of the remote station.
Local Port
Port address of own (local) station. To simplify matters
you may specify the same port address for remote and
local.
Buttons
Connect
The connection is established and prepared for the write
operation.
GetState
Via the connection established by
Connect
, the status of
the CP is transferred and monitored in the status window.
This may be seen:
- Hardware-Stop (RUN/STOP lever at the CP is in STOP
position)
The CP is not remoteable with the test program.
- Hardware-Run (RUN/STOP lever at the CP is in RUN
position)
The CP is remoteable with the test program.
- Software-Stop (RUN/STOP lever at the CP is in RUN
position)
The CP has been switched to STOP with
SetStop
.
- Software-Run (RUN/STOP lever at the CP is in RUN
position)
The CP has been switched to RUN with
SetRun
.
SetStop
The CP is switched to STOP. This function is only
available, if the RUN/STOP lever at the CP is in RUN
position.
SetRun
The CP is switched to RUN. This function is only
available, if the RUN/STOP lever at the CP is in RUN
position.
System tab
[1] port
data
[2]
establish a connection
[3]
information bar for the
connection status
[4]
CP status query
[5]
CP in STOP
[6]
CP in RUN
[7]
Status monitor, requested
by GetState
