CPU ADAM 821x
Chapter 4 Deployment of the CPU 821xNET
ADAM 8000 Manual CPU 821x – Rev 1.1
4-23
Select the station to which you wish to transfer the configuration data in the
network
window of WinNCS and activate [Download].
Your project will now be transferred to the RAM of the CPU.
Attention!
After transferring the project into the CPU-RAM you should save the project
additionally in the Flash-ROM. Otherwise the data will get lost at power off.
Therefore you are searching the according station in the
network
window.
Click on the right mouse button and choose „Flash“.
The RAM data are now transferred to the Flash-ROM.
Repeat this procedure above for station 2 and don’t forget to save the
project to Flash-ROM.
This concludes the configuration of the CP side. The following pages
contain information on the programming for the PLC section.
