5.0 CFW USER PARAMETERS
•
The scale has 7 User Parameters that can be set by the user.
To set these Parameters press the
[Func]
key. The display
will show the first parameter, "
F0 H-L
".
•
Pressing the
[Tare/
Ï
]
will cycle through the other
parameters.
•
Pressing
[Zero/Enter]
will allow you to enter a parameter
directly for setting or further enter a sub-parameter. Press the
[Print/Esc]
key to leave the parameter unchanged.
•
For setting a new value for the parameter or a sub-
parameter, first enter the parameter or sub-parameter by
pressing the
[Zero/Enter]
key. Then use the
[Pcs/
Í
]
key or
the
[Units/
Î
]
key to move the active/flashing digit to the left
or to the right and use the
[Tare/
Ï
]
key to increment the
flashing digit. Press the
[Zero/Enter]
key to enter the
changed value.
•
Use the
[Print/Esc]
key to leave the parameter.
For example,
When the display shows “
F0 H-L
”, press the
[Zero/Enter]
key.
The display will show “
SEt Lo
” (the sub-parameter). Press
[Zero/Enter]
to set the low limit or press the
[Tare/
Ï
]
to skip
to “
SEt Hi
” for setting the high limit. When all digits have been
set, press [Zero/Enter] to store the value. Display will go
back to the sub-parameter just set, i.e. “
SEt Lo
” or “
SEt Hi
”.
Press
[Print/Esc]
to return to “
FO H-L
”.
Advance to the next parameter (
F1 toL
) by pressing [Tare/
Ï
] if
needed or press
[Print/Esc]
to return to weighing.
@Adam Equipment Company 2007
8
