9
Classic SW260 MK3
Manual
/ English
On the front side you will find an Indicator LED for the operating and standby
modes. Controls for the satellite filter, phase switch, signal on/continous
mode and Sub Level/Filter are located on the rear panel of the subwoofer.
The following tips are intended to assist you at using the controls in the best
manner.
5.1
LED
On the right hand side of the nameplate you’ll find
an LED. It indicates Power on and, in case of an
overload, the function of the protective circuit.
When you turn on your subwoofer, the LED starts
to glow orange, indicating stand-by. As soon as the
subwoofer receives a signal the LED starts to glow
green (operating mode).
5.2
Controls on the rear panel
a)
Mode
This push button allows you to choose between
• Signal On:
woofer starts operation as soon as a
musical signal arrives, and stops after 15 minutes
without a signal.
• Continuous:
the unit is permanently working.
We recommend the ”Signal on” position. It
minimises power consumption and makes handling
very easy.
b)
Subwoofer Phase
With the Phase Switch you can alter the phase of the subwoofer
relative to the satellites. That means to change the polarity of the bass
unit. Depending on the distance between woofer and satellites, either
0° or 180° may be the better position. We recommend to try out what
position sounds better within your system.
5.
Controls
SW260 Mk3
LED
