3
1- SAFETY WARNINGS
For the user’s own safety, the safety of data and this product read the
following safety instructions carefully before using the unit!
- This system has been designed to provide all the necessary safety conditions
needed to
protect electronic office equipment including information systems. In case of any
questions, refer
to your authorized technical service representative.
-
In order to avoid any damage to the equipment, it is advised to transport it in its
own packing.
- In the event of sudden temperature changes such as from cold to the normal
working temperature, mist can form inside the STABILIZER. It is absolutely
essential that the STABILIZER be dry before switching it on. Due to this reason
wait for at least 2 hours before operating it.
- Once dry, make sure you observe all the conditions in the environment section of
the technical specifications table, before introducing it into the circuit.
- When installing the STABILIZER it is necessary to use a connection cable of
suitable diameter. The point to be noted here is that the neutral and the earthing
connections should be done in the proper way.
- Place all the cables in a proper place so that they are not stepped on or get
caught into peoples feet. Before connecting the STABILIZER to the circuit make
sure you carefully read all the instructions and warnings in the “Montage and
Operating “ section of this manual.
- Don’t drop any foreign materials (like clips, nails etc...) into the equipment .
- In emergencies (damage to the cabin, front panel, or mains connections,
splashing of liquid dropping of any foreign materials into the equipment) switch-off
the STABILIZER, pull out the plug and inform the authorized service center.
- The STABILIZER can only be repaired by the authorized technical service
personnel. Any attempt to open and to repair by the user on his own could prove
to be dangerous.
