6
4- MONTAGE & OPERATING
Check if the STABILIZER has been subjected to any damage before unpacking it.
If you notice any damage then contact to transport firm.
Check if all the spare parts have been supplied with the STABILIZER.
Delivered pack includes:
• Automatic Voltage Regulator
• User Manual
By the help of rolling wheels, carry the unit to a suitable location to install it.
Plug the input power cable of STABILIZER to properly earthed mains.
Check the connections before changing the position of the input, output, and bypass
switches to suitable positions.
If there is any circuit breaker or fuse on the mains line of Automatic Voltage
Regulator, switch it to ON position. Switch the input fuse to ON position on the
STABILIZER. Switch the mechanic by-pass
Switch to REGULATOR (2) position.
Automatic Voltage Regulator is operating now. During the start, RED signal lamp is
lighting and voltmeter is working. When the output voltage is displayed normally,
STABILIZER will start automatically.
During this time there will be voltage on output clemens and plug.
Connect the load to the circuit.
When the main is out of tolerance STABILIZER will STOP automatically. When the
mains return to normal limits regulator will START automatically.
Regulator will be out of circuit during the MAINS (1) position of mechanic bypass
switch. During this time there will be voltage on output clemens and plug.
In three phase regulators, automatic phase protection is available. If one of the input
phases is OFF or unstable, other 2 phases will be cut off automatically.
