CLEARPASS
Full-Body Security Screening System
OPERATION
MANUAL
Identification
ADN190.00.00.000 OM2
Revision
1
Date
02.2022
Page
46 of 52
6
MAINTENANCE
6.1. GENERAL
The types of the inspections and maintenance (further referred to as the maintenance)
mentioned below, as well as the suggested time intervals are compulsory, serving the ensuring
of performance and safety, timely warning of the possibility of failure or deterioration of func-
tioning.
The purpose of the maintenance is to ensure trouble-free operation of the System, safety
and retention of the technical characteristics of the equipment for the specified lifetime.
The maintenance (M) procedure comprises:
1)
daily M1
2)
periodic M
−
every six (6) months – M2,
−
every twelve (12) months – M3.
Daily M1 is performed by the personnel of the user.
Periodic M2 and M3 of the System are performed by the service specialists of the man-
ufacturer or by the service organization authorized by the manufacturer.
6.2. SAFETY INSTRUCTIONS WHEN PERFORMING THE MAINTENANCE
Always follow the maintenance safety instructions listed below:
−
Switch OFF the system prior to performing external inspection and cleaning.
−
Use ONLY serviceable tools to perform all kinds of maintenance work.
6.3. MAINTENANCE PROCEDURE
6.3.1 Daily maintenance procedure (M 1)
Every day prior to the inspection, it is required to perform visual inspection of the System
to check for the external damage, protective housing integrity, the condition of the plugs and
When M2 and M3 of the System is performed by the individuals,
who are not service specialists of the manufacturer or the ones
of the service organization authorized by the manufacturer, as
well as failure to perform the maintenance or untimely mainte-
nance exempt the manufacturer from the obligations for war-
ranty repair.
