For detailed instructions on how to use the software, please visit
01
KELVIN M300
Status Request
Operational Instructions
docs.adaptloggers.com/kelvinm300
Charge the device to
100% battery. You will
see the red charging
LED turn green.
04
Action to be
performed
Start recording
Stop recording
Downloading
Status request by single click of the button will have the following possibilities:
Only temperature. No REC or END
Press 3 secs
Press 3 secs
Scan QR/Connect device
“REC” icon on LCD
“END” icon on LCD
END starts blinking
Instruction
LCD display indication observed
Status indicated
Confirmation Indication
05
06
Switch on the trip by pressing
the button for 3 secs. You
should see “REC” icon on the
LCD display. Place the probe
inside the package.
02
03
Disconnect the charger and
attach the Probe to the
USB-C port.
Use the LCD Display or scan
the QR on the device to check
the status of the device. Make
sure that the status is not
“paired”.
After the trip is started, there
is a preset precooling delay
set for the device. Tempera
-
ture records during this
period are not included in the
trip report.
Recording starts after precool
-
ing delay period after starting
the trip. To check the status of
the device or alarms during the
trip, scan the QR or check the
display of the device
07
Press the button for 3 secs to
stop the trip. Scan the QR to
access the trip report
REC blinking and delay interval shown
Static REC with bell icon
Static REC without bell
END blinking with bell
END blinking without bell
pre-rec mode
rec-delay mode
Recording mode and
at least one violation has
been recorded
Recording ended and no
violation has been recorded
Recording ended and at
least one violation has been
recorded.
Recording ended and no
violation has been recorded
www.adaptloggers.com
+91-8639739890
info@adaptideations.com
single
click of
button
