23
Motor disengagement check-up
Make sure that the
handle for disengaging
and engaging the motors
is functioning.
Replacing the batteries
Remove the plastic cover, fastened by Velcro.
Loosen the wing nut holding the battery bracket
and remove this. Raise the rear battery upright.
Disconnect the cables and remove the battery.
Push the remaining battery as far back as pos-
sible, raise it up and remove it.
When new batteries
are connected it is
very important that
they are correctly
placed.
First connect the
minus then the
plus poles.
Power
Batteries
Carony Go is powered by 2 motors, one for each
wheel. The motors are placed under the plastic
cover of the wheel unit.
Under the plastic cover of
the wheel unit.
The Batteries of the wheelchair are of gel type and
therefore don’t need any liquid check-up.
Regular charging prolongs the lifetime of the batteries.
When Carony Go is not in use - connect to
battery charger!
BEFORE using Carony Go for the first time,
the batteries must be charged.
Charging the batteries
Batteries shall be charged in a ventilated area, using a
charger of type IVO 24/6 IP65.
The charge socket is placed in the front edge of the
control box.
This diagram is placed on the inside of the plastic
cover and shows how the batteries are connected.
Make sure to turn in used batteries to
the collection point for harmful waste!
Charge socket
battery
battery
!
When the battery is charging the charger lamp flashes.
When the battery is fully charged the lamp shines
constantly.
Battery status
left: low right: high
Summary of Contents for CARONY GO!
