Software Installation and User’s Guide
29
Getting Started
6. Insert the floppy in the floppy drive and press Enter. The command prompt window
closes automatically after the diskette has been written.
7. Exit the DemoShield by pressing <Esc> or clicking on the window’s Close icon (the
‘X’ at the upper right corner of
Figure 2-11
).
2.2.2.2
Create OpenServer ICP RAID Driver
1. On a OpenServer system, insert the RAID Software Suite CD-ROM and go to the
apps
folder.
2. Create a folder on the system hard drive and copy the rawrite.exe application to that
folder.
3. Open the
Opensv5x
folder on the CD-ROM, then open the
dskimg
folder.
4. Copy sco5x.img to the folder created in
step 2
.
5. Open a command window. From the command prompt, go to the folder created in
step
2
and type the following command: “rawrite”.
6. Enter the file name: “sco5x.img” and the floppy drive name (usually “a:”).
7. Insert a blank floppy diskette in the drive and follow the instructions on screen.
2.2.2.3
Create SCO UnixWare ICP RAID Driver
1. On a SCO UnixWare server, insert the RAID Software Suite CD-ROM and go to the
apps
folder.
2. Create a folder on the system hard drive and copy the rawrite.exe application to that
folder.
3. Open the
unixware
folder on the CD-ROM, then open the
dskimg
folder.
4. Copy unixw7.img to the folder created in
step 2
.
5. Open the command window. From the command prompt, go to the folder created in
step 2
and type the following command: “rawrite”.
6. Enter the file name: “unixw7.img” and the floppy drive name (usually “a:”).
7. Insert a blank floppy diskette in the drive and follow instructions on screen.
2.3
Install the ICP RAID Controller
Refer to the Hardware Guide for the detailed installation procedure for your ICP RAID
controller.
Warning:
SHOCK HAZARDS may be present inside the unit in which this card is being installed.
Disconnect all power cords to the unit before removal of any covers. Follow the warnings
noted in your computer’s user or service manual before installing this board. ONLY after all
the covers are reinstalled should you reconnect the power cords and power up the computer
for the software installation and use.
1. Power off the computer, disconnect power cord(s) and remove the system cover
(consult the documentation that came with your computer system).
Summary of Contents for 2074700-R - ICP Vortex GDT8514RZ RAID Controller
