Section 1: Unpacking and Initial Setup
NOTE: Before removing any of the components, ensure that anti-static precautions
have been taken. The minimum requirement is an anti-static wrist strap and ground-
ing wire.
STEP 1.
Remove all the components from the packaging and place on an anti-static
surface until you are ready to use them.
STEP 2.
Install the disk drives, power supplies and advanced cooling modules into
the enclosure in the locations shown below (install rackmount enclosures in
rack before installing components):
1
2
1
2
0
I
0
I
Disk Drives
LSM
LSM
ACMs
Power Supplies
I/O Module
I/O Module
18F
18F
18F
18F
18F
18F
18F
18F
18F
18F
18F
18F
18F
18F
0
1
2
3
4
5
SAN bloc
Series
0
1
2
3
4
5
2
Gb
2
