3-82
container Commands
container remove file_system
To remove the file system from an array, use the
container
remove file_system
command. Use this command when the
file system on the array is no longer needed.
This command fails if there are open files on the array.
Command Availability
This command is supported on Windows.
Syntax
container remove file_system {container}
Parameters
{container}
Specifies the ID number (0 to 63) of the array from which you
want to remove the file system.
Examples
Before removing a file system from an array, use the
container
list
command to obtain information about any existing arrays.
As the following example shows, there is an array 0 (a volume set)
on this controller:
AAC0>container list
Executing: container list
Num
Total
Oth Stripe
Scsi
Partition
Dr Label Type
Size
Ctr Size
Usage
C:ID:L Offset:Size
-- ----- ------ ------ --- ------ ------- ------ -------------
F: 0
Volume 10.0MB
NTFS
0:02:0 64.0KB:
10.0MB
Summary of Contents for AAR-2020SA
Page 1: ...R Command Line Interface Reference Guide...
Page 107: ...3 76 container Commands container extend file_system page 3 40 container list page 3 50...
Page 170: ...4 24 controller Commands Related Commands controller commands controller details page 4 2...
Page 220: ...7 4 logfile Commands Related Commands logfile commands logfile end page 7 2...
