3-96
container Commands
As the following example shows, there is an array 0 (a mirror set)
on this controller:
AAC0>container list
Executing: container list
Num
Total
Oth Stripe
Scsi
Partition
Dr Label Type
Size
Ctr Size
Usage
C:ID:L Offset:Size
-- ----- ------ ------ --- ------ ------- ------ -------------
D: 0 Mirror 10.0MB
NTFS
0:02:0 64.0KB: 10.0MB
0:02:0 10.0MB: 10.0MB
The following example assigns two SCSI failover disks to array 0. If
you assign only one SCSI disk as a failover device, ensure that there
is sufficient freespace. If you assign more than one SCSI disk as
failover devices, you need ensure that only one of these disks has
sufficient space. The reason for this is that the failover operation
will look for the disk that has enough space.
AAC0>container set failover 0 (0,3,0) (0,4,0)
Executing: container set failover 0 (CHANNEL=0,ID=3,LUN=0)
(CHANNEL=0,ID=4,LUN=0)
Use the
container show failover
command after using the
container set failover
command to display information
about the array just assigned failover disk(s).
Related Commands
container
commands:
■
container list
(
page 3-50
)
■
container remove failover
(
page 3-80
)
■
container show failover
(
page 3-108
)
Summary of Contents for AAR-2020SA
Page 1: ...R Command Line Interface Reference Guide...
Page 107: ...3 76 container Commands container extend file_system page 3 40 container list page 3 50...
Page 170: ...4 24 controller Commands Related Commands controller commands controller details page 4 2...
Page 220: ...7 4 logfile Commands Related Commands logfile commands logfile end page 7 2...
