4-18
controller Commands
Syntax
controller set automatic_failover
[/failover_enabled{=boolean}]
/failover_enabled{=boolean}
Specifies whether to turn on or off automatic failover on the
specified controller. You must set this switch to
TRUE
if you
want to turn on automatic failover on the specified controller.
To turn off automatic failover on the specified controller, set
this switch to
FALSE
. The command defaults to
TRUE
, which
means the command turns on automatic failover on the
specified controller.
Examples
Before turning the automatic failover feature on or off, check its
status by using the
controller show automatic_failover
command.
The following example shows that the controller’s automatic
failover is currently disabled:
AAC0> controller show automatic_failover
Executing: controller show automatic_failover
Automatic failover DISABLED
The following example turns on (enables) the automatic failover
feature for the currently opened controller:
AAC0> controller set automatic_failover /failover_enabled
Executing: controller set automatic_failover /failover_enabled=TRUE
The
controller show automatic_failover
command
indicates that the controller’s automatic failover is currently
enabled:
AAC0> controller show automatic_failover
Executing: controller show automatic_failover
Automatic failover ENABLED
Related Commands
array
commands:
■
array set failover
(
page 3-95
)
■
array set global_failover
(
page 3-97
)
controller
commands:
■
controller show automatic_failover
(
page 4-21
)
Summary of Contents for AAR-2020SA
Page 1: ...R Command Line Interface Reference Guide...
Page 107: ...3 76 container Commands container extend file_system page 3 40 container list page 3 50...
Page 170: ...4 24 controller Commands Related Commands controller commands controller details page 4 2...
Page 220: ...7 4 logfile Commands Related Commands logfile commands logfile end page 7 2...
