9-15
enclosure Commands
enclosure set fan
To set the speed of a specific fan on a specific SAF-TE enclosure
management device, use the
enclosure set fan
command.
Syntax
enclosure set fan [/off{=boolean}] {enclosure}
{fan} [{speed}]
Parameters
{enclosure}
Specifies the ID associated with the enclosure management
device on which you want to set the speed of a specific fan.
For this version, the controller supports a maximum of eight
enclosure management devices on each bus.
{fan}
Specifies the unit number associated with the fan whose
speed you want to set. The unit number for the fan ranges
from 0 to 15 inclusive.
{speed}
Specifies the speed at which you want to set this fan.
Table 9-3
lists the fan speed values you can specify.
Table 9-3 Fan Speed Values
The fan speed defaults to full speed.
Value
Meaning
0
Turns off the fan
1
Runs the fan at 1/4 the full speed.
2
Runs the fan at 1/2 the full speed.
3
Runs the fan at 3/4 the full speed.
4
Runs the fan at full speed.
Summary of Contents for AAR-2020SA
Page 1: ...R Command Line Interface Reference Guide...
Page 107: ...3 76 container Commands container extend file_system page 3 40 container list page 3 50...
Page 170: ...4 24 controller Commands Related Commands controller commands controller details page 4 2...
Page 220: ...7 4 logfile Commands Related Commands logfile commands logfile end page 7 2...
