3-27
container Commands
container create stripe
To create a stripe set from freespace, use the
container create
stripe
command.
Notes
If you created a stripe set you can run the
list devices
command on the NetWare console to verify its creation and then
create the necessary NetWare disk partitions and volumes.
For information on how to create partitions and volumes, see the
appropriate NetWare documentation.
Syntax
container create stripe [/cache{=boolean}]
[/stripe_size{=integer}] [/label{=string}]
{free_space} [{scsi_device}...]
Parameters
{free_space}
Specifies the SCSI device and its associated freespace used to
create the stripe set.
For further details, see
free_space
on page 1-11
.
{scsi_device}...
Specifies one or more SCSI devices. A SCSI ID consists of a
SCSI bus number (e.g., 0, 1, 2, 3, etc.), SCSI device ID (0
through 15 inclusive), and SCSI device logical unit number (0
through 7 inclusive). See the installation guide for your
controller to determine the number of buses it actually
supports.
For further details, see
scsi_device
on page 1-10
.
The command uses the freespace(s) from the SCSI device(s) to
create the stripe set. The size from the device is identical to
the one you specify in the
free_space
parameter.
The minimum number of partitions for a stripe set is 2, and
the maximum number is 16.
Summary of Contents for AAR-2020SA
Page 1: ...R Command Line Interface Reference Guide...
Page 107: ...3 76 container Commands container extend file_system page 3 40 container list page 3 50...
Page 170: ...4 24 controller Commands Related Commands controller commands controller details page 4 2...
Page 220: ...7 4 logfile Commands Related Commands logfile commands logfile end page 7 2...
