Connecting and Powering On
Note: Windows 98SE users only
—You must install the device
drivers
before
connecting and powering on the enclosure.
To connect the cables and power on:
1. Connect your enclosure to your computer using
either
the included USB
or
eSATA cable:
Connect the USB cable from the USB 2.0 port on the enclosure to a USB
2.0 port on your computer,
or
Connect the eSATA cable from the eSATA port on the enclosure to an
eSATA port on your computer.
Note: Do not
connect both the USB 2.0 and eSATA cables.
2 Use the included power adapter to connect the enclosure to a grounded power
supply.
3 Power on the enclosure by pushing the on/off switch on the back of the
enclosure to the
I
position.
The LED on the front of the enclosure illuminates.
Note:
The LED flashes when there’s activity on the disk drive.
You have successfully installed and connected your Adaptec ACS-300 enclosure.
6
