&KDSWHU/*'78VHUV0DQXDO
[""""K
BLANK CHECK. Indicates that a write-once device or a sequential ac-
cess device encountered blank medium or format-defined end-of-data
indication while reading or a write-once device encountered a non-
blank medium while writing.
[""""K
VENDOR-SPECIFIC. This sense key is available for reporting vendor
specific conditions.
[""""$K
COPY ABORTED. Indicates a COPY, COMPARE, or COPY AND VERIFY
command was aborted due to an error condition on the source device,
the destination device, or both. (See 8.2.3.2 for additional information
on this sense key.)
[""""%K
ABORTED COMMAND. Indicates that the target aborted the command.
The initiator may be able to recover by trying the command again.
[""""&K
EQUAL. Indicates a SEARCH DATA command has satisfied an equal
comparison.
[""""'K
VOLUME OVERFLOW. Indicates that a buffered peripheral device has
reached the end-of-partition and data may remain in the buffer that
has not been written to the medium. A RECOVER BUFFERED DATA
command(s) may be issued to read the unwritten data from the buffer.
[""""(K
MISCOMPARE. Indicates that the source data did not match the data
read from the medium.
["""")K
RESERVED.
//
''HHLLQQLLWWLLDDOLOL]]H
H''LLVVNN
This menu option allows you to de-initialize a SCSI hard disk which has previously been
initialized for use with the ICP Controller. By doing so, the specific GDT information present
on the device is canceled. Obviously, the deinitialization cannot restore data that was lost
during initialization.
//
//RRFFN
N88QQOORRFFN
N''LLVVNN
This option is only high-lighted when you have selected a removable hard disk (e.g., Sy-
quest, Iomega). Before you can initialize a cartridge you have to lock it. Before removing it
you have to unlock it.
//
&&RRQQIILLJJXXUUDDWWLLRRQ
QRRII66$$))77(
(66XXEEVV\\VVWWHHP
PVV
Before you can use the Auto Hot Plug with a SAF-TE subsystem, you first have to configure
the subsystem (more precisely it's intelligence, the so-called SEP - SAF-TE Enclosure Proc-
essor).
In the following list of devices, the entry "nStor CR8 SAF-TE1.06" represents the SEP of the
connected SAF-TE subsystem. Each SCSI channel requires its own SEP.
