Page 12/29
Vidar
Installation
Guide
Adaptive Recognition
America
Adaptive Recognition
Hungary
Adaptive Recognition
Nordic
Adaptive Recognition
Singapore
REQUESTINFO@ADAPTIVERECOGNITION.COM
WWW.ADAPTIVERECOGNITION.COM
5.
INSTALLATION STEPS
5.1.
POWER SPECIFICATIONS
The required input voltage is model dependent, please use the proper input according to your model!
Please consider voltage drop if you use cables!
Camera with HDx sensor
Camera with FullHD sensor
AC Input
isolated 24 - 28V AC (sinusoidal)
Power (typical)*
11
–
19 W
18
–
26 W
Power (max. / max. with heating)
25 / 51 W
26 / 52 W
Over-current Protection
by fuse
* - Depending on usage and configuration
Suggested power source with fuse protection:
AC/AC transformer:
Type: BREVE PSS 63/230/24V
Main parameters: 63W, 230Vac input, 24Vac output, 2.6A, IP30.
Procurement source: TME PSS63/230/24V
Product: Glass Fuse
Current Rating: 3.15A
Fuse Type: Time delay / Slow Blow
Fuse Size: 5 mm x 20 mm
Voltage Rating AC: 250 VAC
Mounting Style: Holder / Clips
Minimum Operating Temperature: -
55 °C
Maximum
Operating Temperature: + 125 °C
** - Please use the following fuse protection or equivalent:
Littelfuse Cartridge Fuses 02183.15MXP
Distributor: Mouser: 576-02183.15MXP
1.
When performing a power reset, please wait at least 10 seconds before turning your
power source on again.
2.
Please make sure that the power cable is firmly connected to the camera before the
power is applied when installing the device.
For safety reasons please use proper fuse** protection on input power at the source.
To power off the camera (e.g. in case of relocation) please disconnect the power cord from
the device by releasing the screw locking mechanism of the power connector, or disconnect
the 24-28 VAC 50Hz power source from the camera power cord.
