User Manual
V090513
- 6 -
Hardware Installation Procedures
Please follow below procedures to complete the hardware installation:
1
) Open the package, take out the product, make sure the product is
brand new and
all the necessary parts are included (Please check
with Accessory List).
If damage or shortage occurred, please contact your distributor
or where you bought.
2) Unlock the upper and lower covers (see picture C), push the lock
rightward and open the two covers and then, put the two 2.5" SATA
SSDs/HDDs into the box (See Picture D).
3) After both SSDs/HDDs installed, push both covers back like picture
C and then, push the lock button leftward to lock both covers to
secure the SSDs/HDDs inside properly.
4) Then, mount the 3.5” enclosure on the 3.5” space using the included
screws to mount it on the device (desktop, case… etc.) and make all
the cable connected properly and it is ready for use.
5) See the drawing of the two ways to mount the 3.5” enclosure on the
Device (See Picture E).
