© ADB SAFEGATE All Rights Reserved
7
2.2.3 Checking the Device
2.2.3.1 Scope of Supply
The AGLAS-C Remote single channel is supplied with two 12-inch (30 cm) cord-set cables for connection to the series transformer
and the light.
The AGLAS-C Remote dual channel is supplied with three 12-inch (30 cm) cord-set cables, 1 for connection to the series
transformer and 2 for connection to the lights.
The AGLAS-C Remote single channel RGL is supplied with two 12-inch (30 cm) cord-set cables for connection to the series
transformer and the light, adjusted at the factory for configured start-up after switching on (consistent adjustment for all RGL
Remotes in a project).
The AGLAS-C Remote dual channel RGL is supplied with three 12-inch (30 cm) cord-set cables, 1 for connection to the series
transformer and 2 for connection to the lights; adjusted at the factory for configured start-up after switching on.
See “Parts” on page 23” for the complete list of remote variants.
2.2.3.2 Unpacking
The device has been fully assembled, tested and packed at the factory and has no internal transport locks.
2.2.3.3 Inspection
The delivery must be checked to make sure that it is complete and in perfect condition. The supplier must be notified of any
complaints within 2 weeks. After this period, complaints about the delivery will not be accepted. In the event of the goods being
returned, the same transport packaging must be used. See Figure 2.
The number on the nameplate must be checked against the order number on the delivery note.
The nameplate is located on the side of the device (example: AGLAS-C Remote single channel).
Figure 2:
Nameplate of the AGLAS Remote Duel Channel
For commissioning, the serial number on the nameplate (e.g. serial number
4015000220
,
see Figure 2) must be recorded. This is then utilized for installation and configuration.
