Warning
When working on or carrying out measurements on the device, the following basic rules must be followed:
•
The device must be disconnected from the incoming power supply (isolated).
•
The device must be secured against being accidentally switched on.
•
Disconnection must be measured or checked.
The housing must not be opened until all electrical supply cables have been disconnected for at least 5 minutes.
When the housing is open, the incoming power and the high voltage on the series circuit are exposed and freely
accessible at various locations. For this reason, work or measurements on the component assemblies are only
permitted when there is a second person in the room who will be able to take appropriate action in the event of an
accident. Only potential-free instruments may be used for measurements on componentry.
•
Components still carry hazardous or deadly voltages even after being switched off.
•
ESD susceptible devices (ESDS): Components susceptible to damage by electrostatic discharges
•
The component assemblies contain components that are susceptible to electrostatic discharges. These
components can be very easily destroyed if not handled properly. However, if it is necessary to work on electronic
assemblies, follow the instructions below:
•
Electronic assemblies should only be touched if working on them is absolutely necessary.
•
If assemblies have to be touched, the bodies of those working on them must be discharged to ground
immediately prior to contact.
•
Connection pins and printed circuit conductors must not be touched. Assemblies must only be held by the edge.
•
Assemblies may not be brought into contact with highly insulating materials – e.g. plastic parts, insulating table
tops, or clothing made of artificial fibers.
•
Assemblies may only be placed on conductive surfaces.
•
Assemblies and components must only be stored or shipped in conductive packaging (such as metallic or
metallized plastic containers).
•
If the packaging itself is not conductive, assemblies must be wrapped in a conductive material before packing.
96A0480, Rev. B, 2019/12/06
21
Copyright
©
ADB Safegate, All Rights Reserved
Summary of Contents for RELIANCE Intelligent Lighting Platform II
Page 2: ......
Page 38: ...RELIANCE Intelligent Lighting Platform II Parts 32 Copyright ADB Safegate All Rights Reserved ...
Page 42: ......