P.DG A4001N
© (2011) ADB Broadband S.p.A. All Rights Reserved. Proprietary Use Pursuant to Cover Page Instructions.
16
Hardware Installation
FIGURE 3.
Phone Cable Connection
To connect the Ethernet cable:
1.
Connect one end of the Ethernet cable into one of the four Ethernet ports on
the rear of the Data Gateway
2.
Connect the other end of the Ethernet cable into the Ethernet Network card
of your computer
3.
Verify if the Ethernet Network card is configured as DHCP client, otherwise
configure it to remain in the same local network of the Data Gateway inter-
face (see chapter “Setting Up Your Computer”)
The LAN port on the Data Gateway auto-negotiates the connection speed and
the duplex mode with the connecting device.
Use twisted-pair cabling to connect the Data Gateway to an Ethernet adapter on
your PC. Otherwise, cascade any of the LAN ports on the Data Gateway to an
Ethernet hub or switch. When inserting an RJ-45 connector, be sure the tab on
the connector clicks into position to ensure that is properly seated.