Page 14
Rev. : 002
HF - VISION 10 & PHOENIX
Lighting Technologies
You can select between two different operating modes:
-
direct
any key code is directly sent to the receiver. You do not have to confirm an
operation before it is sent to the receiver
-
command line mode
any key that has to be sent to the receiver is first stored in an internal buffer and is
only sent to the receiver when the key SEND is used. Thus, complete key
sequences can first be set up and then transmitted.
The symbol
on the left of display points to the selected operating mode that is currently
active (DIRECT in the above shown example).
Default is 'direct' mode. Toggle between the two modes by using the keys 'up'
↑
and
'down'
↓
.
6.2.1.3. Room Number
Key sequence:
Display :
10:15
MENU MENU=EXIT
ROOM No. 1
UP & DN TO SEL.
As HF signals can easily pass through walls, and as two different rooms can be located
very close to one another, every room can be allocated its own virtual room number
between 1 and 16. A user operating a hand-held transmitter being set to room number
1 cannot operate in a room where a VISION 10 system is set to any other room number.
Using this function should avoid accidental blind operations to beneighboured rooms.
You can select the number between 1 and 16 by using the keys 'up'
↑
and 'down'
↓
.
6.2.1.4. Product ID Number
Key sequence:
Display :
10:15
MENU MENU=EXIT
ID No. 1
UP & DN TO SEL.
MENU
2
→
→
→
→
→
MENU
→
→
→
→
→
3
