rapidly, then turn off. Continue holding the key on the original remote until the LED blinks twice.
NOTE:
If the LED displays one long blink, a learning error has occurred. Try repeating this step again
until a successful capture occurs. If the function is still not captured, press and hold
SETUP
to exit
programming and review the “Learning Precautions” on the previous page. If needed, also see
“Troubleshooting” on page 15. After review, start programming again at step 1.
6. Repeat steps 2 through 5 for another mode and/or key or press and hold
SETUP
until the active mode key LED
blinks twice to exit programming.
Deleting a Single Learning Key
This process returns the key to its original programming for the mode you select. You can also delete learned
programming by teaching a different function to the key (see “Programming a Learned Key” on page 10)
NOTE:
If more than 15 seconds pass between key presses, the remote exits programming.
1. Press and hold
SETUP
until the last-selected mode key blinks twice, then press
9 7 6
.
2. Press a mode key once (i.e.,
TV, AUD, DVD, AUX,
or
STB
). The LED on the selected mode key will blink
once.
3. Press the key containing the learned function to be deleted twice. The active MODE key will blink twice.
4. Repeat steps 2 through 3 for another key or press and hold
SETUP
to exit programming.
Deleting All Learned Keys in a Specific Mode
NOTE:
If more than 15 seconds pass between key presses, the remote exits programming.
1. Press and hold
SETUP
until the last-selected mode key blinks twice, then press
9 7 6
.
2. Press a mode key twice (i.e.,
TV, AUD, DVD, AUX,
or
STB
) to clear all the learned keys for that mode. The
mode key LED blinks twice.
3. Repeat step 2 for another mode or press and hold
SETUP
to exit programming.
PROGRAMMING CHANNEL CONTROL LOCK
By default, the remote control’s channel-control capabilities are locked to the set-top box. The affected keys* are
1
through
0
,
CH+
,
CH-
, and
LAST
. This will guarantee that you do not inadvertently change a channel on your TV or
VCR. However, you can deactivate this feature to allow full access to these keys in the
TV
and
VCR
modes.
*NOTE:
This feature does not affect the
AUD
mode.
Unlocking Channel Control
1. On the remote control, press
STB
once; it will blink once. Press and hold
SETUP
until the
STB
key blinks
twice.
2. Enter
9 7 3
. The
STB
key will blink twice.
3. Press
CH-
once. The
STB
key will blink four times.
Now the remote control will provide TV and VCR channel-control capabilities while in the TV or VCR mode.
Locking Channel Control to STB
1. On the remote control, press
STB
once; it will blink once. Press and hold
SETUP
until the
STB
key
blinks twice.
2. Enter
9 7 3
.The
STB
key will blink twice.
3. Press
CH+
once. The
STB
key will blink twice.
Now, regardless of what mode you select (except
AUD
), the channel keys will only change channels on your set-top
box.
11
