CHANGING VOLUME LOCK
Volume Lock allows you to control the volume through the device identified as having your primary speaker(s),
regardless of which mode you are using. On the Potenza ST Remote Control, Global Volume Lock is set to
TV
, so you
can control TV volume while in the
TV, DVD, AUX
or
STB
mode. You can perform Individual Volume Unlock on a
selected device to set its volume control for independent operation.
NOTE:
The audio mode’s (
AUD
) volume controls are active regardless of Volume Lock settings.
However, if you lock the volume controls to the
AUD
mode, you will have control of the audio device’s
volume in all other modes (i.e.,
TV
,
DVD
,
AUX
, and
STB
). This can be an advantage if, for example,
you always listen to home entertainment devices through your receiver’s speakers.
Unlocking Volume Control for a Single Device (Individual Volume Unlock)
1. Assuming Global Volume Lock is active, select a mode on the remote control that you want to unlock (e.g.,
STB
) and press it once. Next, press and hold
SETUP
until the device key blinks twice.
2. Enter
9 9 3
. The last-selected device key will blink twice.
3. Press
VOL-
once. The last-selected device key will blink four times.
4. Repeat steps 1 through 3 for each device you want volume to be unlocked.
Now, after you select a device that has volume unlocked (e.g.,
STB
), pressing
VOL+
,
VOL-
,or
MUTE
, will control
only that device’s volume.
Unlocking All Volume Control (Global Volume Unlock)
NOTE:
Performing these instructions will set independent volume control for all programmed devices.
1. On the remote control, press and hold
SETUP
until the last-selected device key blinks twice.
2. Enter
9 9 3
. The last-selected device key will blink twice.
3. Press
VOL+
once. The last-selected device key will blink four times.
Locking Volume Control To One Mode (Global Volume Lock)
NOTE:
The audio mode’s volume controls are active regardless of Volume Lock setting s. However, if
you lock the volume controls to the
AUD
mode, you will control the audio device’s volume in all other
modes (i.e.,
TV, DVD, AUX
or
STB
). This can be an advantage if, for example, you always listen to
home entertainment devices through your receiver’s speakers.
1. On the remote control, press and hold
SETUP
until the last-selected device key blinks twice.
2. Enter
9 9 3
. The last-selected device key will blink twice.
3. Select a mode (e.g.,
TV
or
AUD
) which you want to use to control the volume. The selected device key will
blink twice.
Now, when you press
VOL+
,
VOL-
,or
MUTE
, the volume of the selected device (e.g.,
TV
) is controlled regardless
of mode.
PROGRAMMING ID LOCK
The Potenza ST Universal Remote Control is locked at the factory to operate your service provider’s set-top box.
However, if you have another brand or model of set-top box or satellite service that you would like to control, then you’ll
need to perform the following steps to unlock the ID Lock, enter a new manufacturer’s code, and lock the ID Lock again.
1. Turn on the set-top box.
2. On the remote control, press
STB
once; it will blink once. Then press and hold
SETUP
until the
STB
key
blinks twice.
3. Enter
9 8 2
. The
STB
key will blink four times, indicating ID Lock is unlocked.
4. Perform the instructions under “Programming Device Control” on page 8 to program device control for the
desired cable converter or satellite receiver.
12
