150-357-200-02, Issue 2
Provisioning
HXU-357 List 1
February 9, 1999
31
S
ETTING UP THE
C
OMMUNICATIONS
C
HANNEL TO
THE
HXU-357
The AUX port is not available to the user as a craft interface when an
HXU-357 is used in the shelf. HMU-319 List 7 uses the AUX port to
communicate with the HXU-357. HMU-319 List 7A automatically sets up
the AUX port when the IP address is assigned to support IP network
communication with the HXU-357.
1
Log onto the maintenance terminal connected to the HMU craft port.
2
Type
at the prompt (<), and then press
.
3
Type the password, and then press
. The default password is
public
.
4
From the Network Status screen (for multishelf configurations), type the
number of the desired shelf ID (1 through 32), and then press
.
5
From the Shelf Status screen, type
to select Shelf Options.
6
From the Shelf Options screen, type
to configure the Mux port.
7
Do one of the following:
a
If there is an HMU-319 List 7 in the shelf, type
to select the AUX
port as the multiplexer interface.
b
If there is an HMU-319 List 7A in the shelf, type
and enter the IP
address of the multiplexer. Your administrator should supply this
address. Also, refer to
“Appendix B - Network Addresses” on
8
Type
to exit the screen, then
to confirm, save the setting, and return
to the Shelf Status screen.
The following procedures assume some familiarity with the
TAO management software. These procedures are provided
for a quick reference. Please refer to the Wideband 3190
Installation Guide for complete system configuration
information.
TAO
ENTER
ENTER
ENTER
O
E
2
2
X
Y
