150-357-200-02, Issue 2
Provisioning
HXU-357 List 1
February 9, 1999
45
4
From the Network Status screen, type the number of the desired shelf (1
through 32), and then press
.
5
From the Shelf Status menu, select
to log onto the multiplexer.
6
At the multiplexer logon prompt (ID:), type a valid password to display
the Root menu. The default password is
public
.
7
Type
to select System Configuration Status, and select any of the
following status screens. Use these screens to verify system
configuration selections.
DS3 Interface Status
DS1 Interface Status
System Status
IP Addresses
Card Inventory
8
If necessary, access the Configuration Management screen or System
Administration screen to make changes before placing the DS1 and DS3
interfaces in service.
V
IEWING
P
ERFORMANCE AT THE
HXU
Once the line has been installed and tested, you may wish to view the DS1
and DS3 performance data. The DS1 performance data is only associated
with intercage communications between the HXU and the HLU.
1
Log on to the maintenance terminal connected to the HMU craft port, if
you are not already logged on. Type
at the prompt (<).
2
From the Network Status screen, type the number of the desired shelf (1
through 32), and then press
.
To view the DS1 performance of the HDSL line and the
corresponding DS1 customer interface, access the HLU
Maintenance Terminal screens. The HLU Maintenance
Terminal screens provide detailed performance histories.
ENTER
M
4
1
2
3
4
5
TAO
ENTER
