Set Up the Campus-REX System
Campus-REX RS Interface Card User Manual
3-9
1
If the Operating Mode is set to Standard Mode, proceed to
Otherwise, press Enter.
2
Press Next until the LCD displays
STANDARD
, then press Enter. The
Operating Mode changes to Standard.
3
Press Next until
HDSL RATE
displays, then press Enter.
4
Press Next until the desired HDSL transmission rate displays, then
press Enter.
To continue setting up the system, proceed to
as a Bridge or Router” on page 3-19
Extended HDSL Mode
to set the
Extended Mode parameters.
To set an Extended Mode HDSL Rate, you must:
•
Set the Extended Mode Loop Configuration to 1 Loop or 2 Loop,
depending on the physical layout of your HDSL network.
•
Set the Extended Mode HDSL Rate to one of the options determined by
the Extended Mode Loop Configuration:
–
1 Loop HDSL Rate settings are between 128 kbps and 1.152 Mbps,
in 64 kbps increments.
–
2 Loop HDSL Rate settings are between 256 kbps and 2.304 Mbps,
in 128 kbps increments.
1
With the LCD displaying
OPERATING MODE
, press the Enter button.
2
Press Next until
EXTENDED
displays, then press Enter. The LCD
displays
OPERATING MODE
.
3
Press Next two times.
LOOP MODE
displays.
4
Press Enter.
5
Press Next until the desired Loop Mode setting displays, then press
Enter. The LCD displays
LOOP MODE
.
CAD1069i5.book Page 9 Thursday, May 30, 2002 7:32 AM
