Set Up the Campus-REX System
Campus-REX RS Interface Card User Manual
3-13
To set a Standard HDSL Mode:
1
If the HDSL Operating Mode is set to Extended Mode, type
then press
.
2
From the HDSL Parameters menu, type
then press
. The
HDSL Rate option changes to the next setting.
3
Repeat the previous step until the HDSL Rate option is set to the desired
setting.
4
Type
to exit the menu, then confirm any HDSL changes you have
made.
To continue setting up the system, proceed to
as a Bridge or Router” on page 3-19
Extended HDSL Mode
to set an extended HDSL
mode.
To set a Standard Mode HDSL Rate, you choose from the list of predefined
rates. To set an Extended Mode HDSL Rate, you must:
•
Set the Extended Mode Loop Configuration to 1 Loop or 2 Loop,
depending on the physical layout of your HDSL network.
•
Set the Extended Mode HDSL Rate to one of the options determined by
the Extended Mode Loop Configuration:
–
1 Loop HDSL Rate settings are between 128 kbps and 1.152 Mbps,
in 64 kbps increments.
–
2 Loop HDSL Rate settings are between 256 kbps and 2.304 Mbps,
in 128 kbps increments.
1
ENTER
3
ENTER
R
CAD1069i5.book Page 13 Thursday, May 30, 2002 7:32 AM
