Set Up the Campus-REX System
Campus-REX RS Interface Card User Manual
3-23
11
Type the address, in decimal-dotted notation, then press
.
12
Type
then press
to return to the Data Port Settings menu.
13
Type
then press
to write the new bridge configuration to
NVRAM.
14
If you are done making configuration changes, type
then press
to reset the Campus-REX and enable the changes. If you plan to continue
making configuration changes, wait until you have finished before
resetting the system.
Configuring as a Router
“Static IP Routing” on page 7-4
, define how the
Campus-REX operates as a router. Use these options to:
•
enter the address of a default gateway router
•
set Encapsulation to HDLC or PPP:
–
Use HDLC for most applications.
–
Use PPP when the remote unit is a synchronous interface card, such
as a V.35 card.
•
enter up to three destination addresses, subnet masks and gateway
addresses into the IP Static Routing Table
•
enter the IP address and subnet mask for the Campus-REX
This section describes how to configure the Campus-REX as a router.
Make sure you reset the interface card when you have finished
changing bridge/router configuration options. The changes
do not take effect until the system is reset.
You can only configure the Campus-REX as a router through
an ASCII terminal. Router options are not available through
the LCD menus.
ENTER
R
ENTER
3
ENTER
4
ENTER
CAD1069i5.book Page 23 Thursday, May 30, 2002 7:32 AM
