ADCP-75-112
•
Issue 3
•
August 2001
Page 14
©
2001, ADC Telecommunications, Inc.
2.5.4 800 MHz 90º Directional Panel Antenna Installation
The
800 MHz 90º directional panel antenna is designed to mount in the corner of the coverage
area.
Mount the 90º directional panel antenna as shown in Figure 11 and as described in the
following
procedure:
1. Loosen base assembly handle until antenna can be separated from base assembly.
2. Place base assembly against wall near corner and drill holes in wall for fasteners
(installer
provided).
3. Secure base assembly to wall with fasteners.
4. Drill 5/8-inch (16 mm) hole in wall for antenna cable.
5. Insert antenna cable through hole in wall.
6. Reinstall antenna on base assembly.
7. Direct antenna toward center of coverage area and tighten base assembly handle.
8. Route antenna cable to DRU.
16247-B
NOTE: TO COMPLY WITH MAXIMUM
PERMISSIBLE EXPOSURE (MPE) REQUIREMENTS,
ANTENNAS MUST BE INSTALLED TO PROVIDE AT
LEAST 20 CENTIMETERS OF SEPARATION FROM
ALL PERSONS PER FCC 47 CFR PART 2.1091.
MAKE SURE ARROW ON REAR
SIDE OF ANTENNA IS POINTING
UP WHEN ANTENNA IS MOUNTED
5/8-INCH (16 mm) HOLE
FOR ANTENNA CABLE
BASE ASSEMBLY
HANDLE
ORIENT TO CENTER OF
COVERAGE AREA
Figure 11. 800 MHz 90º Directional Panel Antenna Installation
