16
American Dryer Corp.
450325 - 1
B. GLO-BAR CONTROLS
To Remove Globar (refer to the burner illustration)
1.
Discontinue electrical power to the dryer.
2.
Disconnect Glo-Bar connector.
3.
Disassemble ignitor from burner by removing the single ignitor mounting screw.
4.
Reverse procedure for installing new Glo-Bar ignitor.
To Replace Gas Valve
1.
Discontinue electrical power to the dryer.
2.
Close shutoff valve(s) in gas supply line.
3.
Disconnect gas valve wiring.
NOTE:
Identify location of each wire for correct reinstallation.
4.
Break union connection before gas valve.
5.
Loosen and remove the two T-20 Torx screws securing pipe brackets to burner.
6.
Remove gas valve/manifold assembly from dryer.
7.
Remove valve mounting bracket, manifold, and piping from gas valve.
8.
Reverse procedure for installing new gas valve.
WARNING:
Test all connections for leaks by brushing on a soapy water solution. NEVER TEST
FOR LEAKS WITH A FLAME.
Summary of Contents for ES35
Page 34: ...ADC Part No 450325 1 10 28 11...
