LTPH-TP-1044-01, Issue 1
Provisioning
HXU-358 V1.04
April 6, 2001
21
lists the HXU-358 service states to be implemented and also defines
what functions are enabled for each service state. There is a separate service
state for the DS3 port and for each of the 28 DS1 ports.
Configure the HXU-358 T1/E1 interface by selecting T1/E1 Ports from the
Config menu.
To configure any of the ports,
1
Select the port by pressing the
and change its Srvc Mode to
MEM-ADMIN, then press
.
2
Configure the following options:
•
Type of service (T1/E1, default)
•
Line code for T1 (Code)
–
AMI
–
B8ZS (default)
•
Line code for E1 (Code)
–
HDB3
•
Line buildout (LBO) options for the channel (133, 266, 399, 533, or
655 feet), which only pertains to T1 and is not applicable for E1.
Table 4.
HXU-358 T1/E1 Service Modes
HXU-358
Service
States
Passes
Data
Report
Alarms
PM Data
Loopback
Allowed
Config
Changes
Allowed
Out-of-Service
Yes
No
No
Yes
No
In-Service
Yes
Yes
Yes
No
No
Memory
Administration
Yes
Yes
Yes
Yes
Yes
Maintenance
Yes
Yes
Yes
Yes
No
HXU line code must match the type of line code on the HLU or
other equipment driving this port. If uncertain of the line code
type, use the default setting (B8ZS).
SPACEBAR
ENTER
