viii
Front Matter
ADCP-62-023
Issue 1, September 1998
© 1998, ADC Telecommunications, Inc.
CAUTION: Users should not attempt to make such connections themselves, but should contact
the appropriate electric inspection authority, or electrician, as appropriate.
The Ringer Equivalence Number (REN) assigned to each terminal device denotes the percentage
of the total load to be connected to a telephone loop which is used by the device, to prevent over-
loading. The termination on a loop may consist of any combination of devices subject only to the
requirement that the total REN of all the devices does not exceed 5. The RInger Equivalence Num-
ber of this unit is Not Applicable.
FCC PART 15 INFORMATION
This device has been tested and found to comply with FCC Part 15 “Class A” regulations for digi-
tal devices. Operation is subject to the following two conditions: (1) This device may not cause
harmful interference and (2) This device must accept any interference that may cause undesired
operation.
These FCC limits are designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy, and, if not installed and used in accordance with this User Manual,
may cause harmful interference to radio communications. Operation of this equipment in a resi-
dential area may cause harmful interference. If this happens, the user would be required to correct
the interference at his own expense.
FCC REGULATORY REQUIREMENTS
Notice to Users of T1 Service
The following instructions are provided to ensure compliance with the Federal Communications
Commission (FCC) Rules, Part 68. FCC Regulartory Number: 1H5USA-32637-DE-N.
1.
Before connecting your unit, you must inform the telephone company of the following information:
2.
If the unit appears to be malfunctioning, it should be disconnected from the telephone lines until you
learn if your equipment or the telephone line is the source of the trouble. If your equipment needs repair,
it should not be reconnected until it is repaired.
3.
If the telephone company finds that this equipment is exceeding tolerable parameters, the telephone company
can temporarily disconnect service, although they will attempt to give you advance notice if possible.
4.
Under the FCC Rules, no customer is authorized to repair this equipment. This restriction applies
regardless of whether the equipment is in or out of warranty.
Port ID
REN/SOC
FIC
USOC
T1 Line
6.0N
04DU9-BN
RJ48C / Dual Bantam Jacks
T1 Line
6.0N
04DU9-DN
RJ48C / Dual Bantam Jacks
T1 Line
6.0N
04DU9-1KN
RJ48C / Dual Bantam Jacks
T1 Line
6.0N
04DU9-1SN
RJ48C / Dual Bantam Jacks
