Page 10
Advanced Digital Controls
Advanced Digital Controls
AS208-OM-V1.1
MENU 2
MENU 2 -- EXCLUDE MODE
EXCLUDE MODE
This command allows you to temporarily exclude or by-pass zones of your choice when
arming your panel. The excluded zones will go back to normal the next time you disarm
the panel (except 24 Hour zones which must be manually re-included). A typical example
would be if you wanted to let your pet run around in the garage when your system is
armed, you could choose to exclude that detector (say Zone 1) from the system.
To exclude zone 1, key in the following sequence:
MENU + 2 + 1 + ENTER
When the ENTER key is pressed the
AWAY
indicator will flash very fast (provided that all
zones are sealed) to indicate the exclude function is active before arming, any number of
zones may be excluded in this manner. Press MENU 2 again to add or remove excluded
zones. Press button 1and ENTER again and zone 1 will be included.
¤
24 hour zones (for example smoke detectors) will remain excluded until they are
manually included again. All other excluded zones will return to normal "included" mode
automatically the next time the panel is armed.
It is advisable to vacate the secured area before the exit delay expires
You may now ARM the panel.
MENU 3
MENU 3 -- C
C ONTROL MODE
ONTROL MODE
Outputs are programmable contacts on the panel or output expander board that can be
used to switch or power external devices on or off.
Note: Your installer must enable this feature.
Press the MENU 3 button
The
SYS
indicator will be on steady
Press the number key corresponding to the output you wish to turn on i.e.-output 3 turns
on water heating.
Press the 3 key, the 3 indicator will illuminate indicating the output is on.
Press the ENTER key to confirm the operation and return to normal keypad function
To check what outputs are on simply press the MENU 3 keys again, indicator 3 will be
illuminated, pressing the 3 & ENTER keys again will toggle the output off.
www.msealarms.com.au
