Page | 16
Step 2 – Connections
You will need to proper cable to go from the sensors to
the VG03. If you do not currently use the VG03 in
your everyday setup, you will need to get 1 cable per
each emitter and receiver part# 1815-CAB2
Do you have more than 2 set of sensors? If so, you will
need an M12 splitter as the one shown here for
connecting all the sensors to the VG03.
Please refer to the instructions ahead and Figure 2.3
for proper connections.
FIGURE 1.2 - Illustration for connecting 4 set of sensors. The blue arrows indicate the
path of the object as it enters from left to right triggering all sensors.
NOTE: The sole purpose of this diagram is to illustrate proper connections and does
not depict any real setup
.
Begin by connecting the light source, or EMITTER, for your sensors to the EMITTER
connections on the VG03. Emitters can be connected in any order.
FIGURE 1.1 - M12 splitter
Notice the channel numbering on the splitter
.
