4601 I-V Meter Operation Manual
3.3.3 Setting Current Limits
3-14
3.3.3
Setting Current Limits
The procedure of setting the current limits is the same as the procedure described in Section 3.2.2, “Setting
Current Limits.”
3.3.4
Changing Reference Cell Current Range
In the sweep source mode, the ADC3 measurement function is fixed to the reference cell current
measurement function Ir.
The reference cell current measurement range is changed with
or
on the
MEASURE
section. Pressing
lowers the range by one and pressing
raises it by one,
and then displays the changed range for about two seconds.
Example display
3.3.5
Setting Memory Sweep Data
This section describes the procedure of setting memory sweep source data.
Press .
Check
that
1) Sweep Type
is set to
Memory
in category
B) SWEEP
.
Example display
1
1
1
