7351 Series Digital Multimeter Operation Manual
6.7.3 ADC Command Reference
6-22
6.7.3
ADC Command Reference
This section describes the ADC command reference of this instrument.
“Initial value” shows the status when the *RST command is executed.
"R6451" shows a command used when the R6451 command language is selected.
A "-" shows that any related command does not exist.
A blank shows that the same command as the 7351 series can be used.
CAUTION:
Ensure the following when using the USB interface.
The device setting conditions are output by reading the data after executing the query command.
When executing the query command, set a wait time of 20 ms after the last command.
Item
Command
Description
Initial value
R6451
Measurement
Function
F1
DC voltage measurement (DCV)
F2
AC voltage measurement (ACV)
F3
Resistance measurement (2W
)
F5
DC current measurement (DCI)
F6
AC current measurement (ACI)
F7
AC voltage (AC+DC coupling) measurement
(ACV(AC+DC))
F8
AC current (AC+DC coupling) measurement
(ACI(AC+DC))
F13
Diode measurement (Diode)
F20
Low power resistance measurement 2W
-
F22
Continuity test (Cont)
F50
Frequency measurement (Freq)
F?
Reply: One of F1, F2, F3, F5, F6, F7, F8, F13, F20,
F22 or F50
-
Invalid function
INH?n
Reads the invalid state of the function.
n: 1 (DC voltage measurement) to 50 (Frequency
measurement)
Reply 0: Valid state of the function selection
1: Invalid state of the function selection
-
Trigger
*TRG
Trigger command
E
Measurement
data output
request (Only
RS-232)
MD?
Reply: See Section 6.7.2, “Output Data Format.”
