7352 Series Digital Multimeter Operation Manual
6.6.3 ADC Command Reference
6-25
Calculation
PASS
condition
range setting
LOP0
Calculation result LO is not specified as the PASS condi-
tion.
–
LOP1
Calculation result LO is specified as the PASS condition.
–
LOP?
Reply: LOP0 or LOP1
–
MIP0
Calculation result GO is not specified as the PASS condi-
tion.
–
MIP1
Calculation result GO is specified as the PASS condition.
–
MIP?
Reply: MIP0 or MIP1
–
HIP0
Calculation result HI is not specified as the PASS condi-
tion.
–
HIP1
Calculation result HI is specified as the PASS condition.
–
HIP?
Reply: HIP0 or HIP1
–
Statistical
calculation
SIRDn,
m
Sets the statistical calculation range and performs the cal-
culation.
Single measurement mode: n, m: 0 to 19999
Dual measurement mode: n, m: 0 to 9999
NOTE:
1. If the recall data does not exist within the set
range, an error occurs.
2. Parameters cannot be omitted.
(0,-1)
–
SIRD? Reads the statistical calculation range.
Reply: SIRDdddd,dddd
(Initial state: SIRD0000,-0001)
–
Reads the statistical calculation result.
SCNT? Reads the number of samples in the measurement memory.
Reply: SCNT
d.dddddE
dd
*3
–
SMAX? Reads the maximum value in the measurement memory.
Reply: SMAX
d.dddddE
dd
*3
–
SMIN? Reads the minimum value in the measurement memory.
Reply: SMIN
d.dddddE
dd
*3
–
SAVE? Reads the average value in the measurement memory.
Reply: SAVE
d.dddddE
dd
*3
–
SSIG? Reads the standard deviation value in the measurement
memory.
Reply: SSIG
d.dddddE
dd
*3
However, if the number of samples is 1 or less,
SSIG+9.11 is output.
–
SPTP? Reads MAX-MIN in the measurement memory.
Reply: SPTP
d.dddddE
dd
*3
–
*3: The position of the decimal point in the reply is fixed.
Item
Command
Description
Valid
command
for the 2nd
display
setting
Initial
value
R6452