7352 Series Digital Multimeter Operation Manual
8.11 Error Message List
8-25
30
Err 311
Bch RST line error
Repair
31
Err 315
Bch ATT 1/100 measurement test error in analog operation
Repair
32
Err 351
Bch DCFILT reply test error
Repair
33
Err 500
Calibration data error
[CAL data]
Solution3
34
Err 501
ZERO calibration is not performed.
[before ZERO]
Solution4
35
Err-102
Command syntax error
[Cmd Syntax]
Solution5
36
Err-113
The command cannot be used.
[Undefined header]
Solution5
37
Err-121
Unrecognized character as the numerical value
[Invalid character in number]
Solution5
38
Err-141
Invalid character string parameter is entered.
[Invalid character data]
Solution5
39
Err-151
Error as the character string data (Quotation mark error)
[Invalid string data]
Solution5
40
Err-200
Execution error (Command which cannot be executed now)
[Execution error]
Solution6
41
Err-213
The INITiate command is ignored because the measurement is
performing.
[Init ignored]
Solution6
42
Err-214
The READ? or MEAS? command is received when any trigger
source except for IMM is set.
[Trigger deadlock]
Solution6
43
Err-222
Entered value is outside the setting range or lacking for neces-
sary parameters
[Data out of range]
Solution6
44
Err-313
Calibration data is lost.
[Calibration memory lost]
Solution7
45
Err-314
Parameters saved by “*SAV” command are lost.
[Save/recall memory lost]
Solution8
46
Err-315
Saved parameters are lost.
[Configuration memory lost]
Solution6
47
Err-330
Self-test error
[Self-test failed]
Repair
48
Err-350
Error queue overflows.
[Queue overflow]
Solution9
49
Err d
Calculation error (Refer to Section 5.9.4 dB and dBm Calcula-
tions and Section 5.9.8 Calculation between 2 Measurements.)
Solution11
No.
Error display
Error description
[ ]: Response to the ERR? command
Solution
