7352 Series Digital Multimeter Operation Manual
5.9.6 MAX/MIN Calculation
5-35
5.9.6
MAX/MIN Calculation
1. Function
1. This function calculates the maximum, minimum, and average values while the
MAX/MIN calculation is performed.
2. The following calculations are performed at the same time in the MAX/MIN cal-
culation.
• Maximum value (MAX)
• Minimum value (MIN)
• Average value (AVE)
• Measurement count
3. All measured data except for overload (OL) and calculation error data can be
used for the calculation.
4. If BEEP is set to ON, the buzzer sounds when the MAX or MIN value is renewed.
However, although the displayed value is not changed, the buzzer may sound.
This is because the resolution of measured value is higher than the resolution of
the displayed value.
2. Setting the calculation
The operation is changed as shown below by selecting MAX/MIN in
:
NOTE:
Refer to “4. MAX/MIN calculation value display function during the measurement” in this section.
MENU
MENU
CALC
MAX/MIN
OFF/ON/MAX/MIN
MAX
MIN
Turn off
MAX
MIN
Turn on
Canceling the calculation
The MAX and MIN indicators turn off.
Performing the calculation
Any one of the following indicator displays can be
selected. (NOTE)
• The MAX and MIN indicators turn on.
• The MAX indicator blinks.
• The MIN indicator blinks.
