WARNINGS
•
Do not touch any hot surfaces
•
Plug only into a 3-hole grounded electrical outlet
•
Do not immerse unit, cord or plug in liquid at any time
•
Unplug cord from outlet when not in use and before cleaning
•
Do not operate unattended
•
Do not use this unit for anything other than intended use
•
Do not use outdoors
•
Always use on a firm, dry and level surface
•
Do not use if unit has a damaged cord or plug, in the event the appliance malfunctions, or has been damaged in any manner
•
Keep children and animals away from unit
•
Any incorrect installation, alterations, adjustments and/or improper maintenance can lead to property loss and injury. All
repairs should be done by authorized professionals only
•
Ensure that the designated power supply is adequate for continual usage and the voltage is correct
TO USE
1.
Place unit on a firm and level surface.
2.
Plug the unit into a grounded 3-prong 120V outlet.
3.
Place food into the food pan located in the base of the unit. A perforated liner is included to allow for proper drainage of
oil from food.
4.
Set “HEATING” switch to on position. This will turn the heating elements on and start to warm up the food in the food
pan located in the base of the unit. Please note the maximum temperature that the hot zone area should reach is 122°F
(50°C).
5.
Set “LIGHT” switch to on position to turn on display lamp.
CLEANING – NOTE:
To maintain cleanliness and increase service life, the oven should be cleaned daily. Do not immerse the unit
in water or any other liquid. If liquid enters the electrical compartment it may cause a short circuit or electrical shock
•
Disconnect the power cord from the electrical outlet
•
Allow unit to cool down
•
Remove food pan daily to clean. Separate perforated liner and food pan for best results
•
Clean unit with a damp cloth using a mild detergent
•
Do not clean with a water jet stream
•
To avoid damage, do not use abrasive cleaners or scouring pads
•
If soap or chemical cleaners are used, be sure they are completely rinsed away with clear water immediately after cleaning.
Chemical residue could damage or corrode the surfaces of the unit.
SPECIFICATIONS
Item Number
Description
Voltage
Wattage
Amps
Net Weight
Dimensions
IDW-940W
Infrared Display
Warmer
120V
940W
7.8
15.5 lbs
13”x22.25”x19.75”
Thank you for your purchase
Admiral Craft Equipment Corp.
940 South Oyster Bay Rd.
Hicksville, NY 11801
P: 1-800-223-7750
F: 1-800-447-7751
www.admiralcraft.com
