3.
Hold one of the steps in place, then loosely install the 5/16” Bolts (x4) and 5/16” Washers (x4) through
the step mounts and into the newly installed U-nuts. (Fig C)
4.
Line the step up so it is straight in relation to the bottom of the body.
5.
Once the step is lined up, torque the mounting bolts to 20 foot pounds.
6.
Repeat Steps 1-5 on the other side of the vehicle.
7.
Stand back and enjoy your new A.D.D. Lite Side Steps.
8.
Check and re-tighten if needed, all mounting bolts after 100 miles and periodically thereafter.
