10
INST
ALLA
TION
CONFIGURA
TION
OPERA
TION
FUR
THER
INFORMA
TION
INDEX
Local power connection
There is no on/off switch on either of the AdderLink XD150 modules, so operation
begins as soon as power is applied. The power adapters supplied with the modules
use locking-type plugs to help prevent accidental disconnections; please follow the
instructions given right whenever disconnecting a power adapter.
To connect the power adapter
1 Attach the output plug of the supplied power adapter to the
power input socket on the left side of the rear panel.
2 If any mode changes need to be made, adjust the switch settings before applying power
to the local module. Please see the section
Mode switch settings
for details.
3
Connect the IEC connector of the supplied country-specific power cord to the socket
of the power adapter.
4 Connect the power cord to a nearby main supply socket.
To disconnect the power adapter
1 Isolate the power adapter from the mains supply.
2 Grasp the outer body of the power adapter plug
where it connects with the module.
3 Gently pull the body of the outer plug away from
the module. As the body of the plug slides back,
it will release from the socket and you can fully
withdraw the whole plug.
IMPORTANT: Please read and adhere to the electrical safety information
given within the
Safety information
section of this guide. In particular, do not
use an unearthed power socket or extension cable.
Note: Both the modules and the power supplies generate heat when in operation and will
become warm to the touch. Do not enclose them or place them in locations where air cannot
circulate to cool the equipment. Do not operate the equipment in ambient temperatures
exceeding 40 degrees Centigrade. Do not place the products in contact with equipment whose
surface temperature exceeds 40 degrees Centigrade.
From the
power adapter
Gently pull back the plug outer
body to release the lock
